Hide Table of Contents

Adding New Leaders to a Dimension or Hole Callout

This procedure applies to radial, diameter, fillet, and chamfer dimensions and hole callouts.

To add new leaders to an existing dimension or hole callout:

  1. Select the dimension or hole callout.
    dimension_handle.gif
  2. Hold down Ctrl and move the pointer over the arrowhead handle as shown.

    The pointer changes to pointer_multiple_leaders.gif.

  3. Drag the arrowhead to another entity of equal size.
  4. Drop the arrowhead on the new entity and release Ctrl.
    multiple_leaders.gif


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding New Leaders to a Dimension or Hole Callout
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46