Hide Table of Contents
ICWLoadsAndRestraintsManager Interface Members

The following tables list the members exposed by ICWLoadsAndRestraintsManager.

Public Properties

 NameDescription
PropertyCount

Gets the number of loads and restraints defined in the active study.

 
Top

Public Methods

 NameDescription
MethodAddBearingLoadAdds a bearing load.  
MethodAddBoltConnectorAdds a bolt connector.  
MethodAddCentrifugalForceCreates a centrifugal force.  
MethodAddConvection

Creates convection for thermal studies.

 
MethodAddDistributedMassCreates a distributed mass.  
MethodAddElasticConnectorAdds an elastic connector.  
MethodAddForce

Obsolete. Superseded by ICWLoadsAndRestraintsManager::AddForce2.

 
MethodAddForce2

Obsolete. Superseded by ICWloadsAndRestraintsManager::AddForce3.

 
MethodAddForce3

Creates a force.

 
MethodAddGravity

Creates gravity.

 
MethodAddHeatFluxCreates heat flux for thermal studies.  
MethodAddHeatPower

Creates the heat power for thermal studies.

 
MethodAddInitialConditionForDynamicStudyCreates the initial (time = 0) displacements, velocities, or accelerations in modal time history and nonlinear dynamic studies.  
MethodAddLinkConnectorAdds a link connector.  
MethodAddPinConnectorAdds a pin connector.  
MethodAddPressure

Creates pressure.

 
MethodAddRadiationCreates radiation for thermal studies.  
MethodAddRemoteLoadCreates a remote load of the specified type at the specified location.  
MethodAddRestraintCreates a restraint.  
MethodAddRigidConnectorAdds a rigid connector.  
MethodAddSelectedBaseExcitationApplies a base excitation to the specified restraint along the specified directions for dynamic studies.  
MethodAddSpotWeldConnectorAdds a spot weld connector.  
MethodAddSpringConnectorAdds a spring connector.  
MethodAddTemperature

Creates temperature.

 
MethodAddUniformBaseExcitationAdds a uniform base excitation to all locations restrained in the specified directions for dynamic studies.  
MethodDeleteLoadsAndRestraints

Deletes a load or restraint.

 
MethodGetLoadsAndRestraints

Gets the load or restraint at the specified index.

 
Top

See Also



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   ICWLoadsAndRestraintsManager Interface Members
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46