Hide Table of Contents

Inferencing to the Assembly Origin

When you insert a component by various means, you can inference the assembly origin.

  • Look for the pointer shown here when you point to the origin.

    When you inference the assembly origin:

    • The component origin is coincident with the assembly origin.
    • The planes of the component and the assembly are aligned.
    You can also create an inference to the assembly origin by dropping the component in the FeatureManager design tree of the assembly window.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Inferencing to the Assembly Origin
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.