Hide Table of Contents

Creating a Weld Bead on a Multibody Part

To create a weld bead on a multibody part:

  1. Open install_dir\samples\whatsnew\weldments\Multi Body Weld Test.sldprt.
  2. Click Weld Bead (Weldments toolbar) or Insert > Weldments > Weld Bead.
  3. In the Weld Bead PropertyManager, under Settings, select Weld Geometry.
  4. In Weld From, select the face of Gusset1.

  5. In Weld To, select Face2 and Face3 of StructuralMember1.

    A preview of the weld between the selected faces displays.

  6. For Bead Size, type 6mm.
  7. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Weld Bead on a Multibody Part
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.53