> Example: Deform - Curve to Curve Maintain Boundary

Introduction

Administration

User Interface

SOLIDWORKS Fundamentals

Design Studies in SOLIDWORKS

Detailing and Drawings

Sustainability Products

Example: Deform - Curve to Curve Maintain Boundary

Initial part to deform. The two curves are used for this curve to curve deform example. The top face is selected for deforming in all the following examples.

Preview with Maintain boundary cleared and Additional faces only selected. Under Deform Region, the top face is selected for Additional faces to be deformed .

Results - The entire model is affected. The side faces are included in the deform.

Preview with Maintain boundary selected. The top face is selected for Additional faces to be deformed .

Results - Only the top face is affected.

Parent topic

Deform - Curve to Curve Options

Search 'Example: Deform - Curve to Curve Maintain Boundary' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Example: Deform - Curve to Curve Maintain Boundary
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.