> DFMXpress > DFMXpress Overview > Rule Descriptions > Drill Rules > Hole Entry and Exit Surfaces

Introduction

Administration

User Interface

SOLIDWORKS Fundamentals

Design Studies in SOLIDWORKS

Detailing and Drawings

Holes with Flat Bottoms

Hole Entry and Exit Surfaces

Holes Intersecting Cavities

Partial Holes

Linear and Angular Tolerances

SOLIDWORKS Sustainability

Hole Entry and Exit Surfaces

The entry and exit surfaces of a drilled hole should be perpendicular to the hole axis. The drill tip can wander if the surface that the tip contacts is not perpendicular to the drill axis. Exit burrs will be uneven around the circumference of the exit hole, which can make burr removal difficult.

Search 'Hole Entry and Exit Surfaces' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Hole Entry and Exit Surfaces
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.