Hide Table of Contents

Layer Properties

You can view layer properties from the Layer Properties panel.

To open the Layer Properties panel for a layer:

From the tree view, expand Layers , right-click a layer, and click Properties.

Number Specifies a integer label for the layer.
Type Specifies the type of layer:

Conductor apri5copperconductorlayer.gif

Dielectric apr5dieletriclayericon.gif

Start height Specifies the height of the bottom of the layer relative to the bottom of the board.
End height Specifies the height of the top of the layer relative to the bottom of the board.
The end height of one layer is the same as the start height of the next layer
Thickness (mm) Specifies the thickness of the layer.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Layer Properties
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.