Hide Table of Contents

Run Specified Studies

You can select which Simulation studies to run from the list of all Simulation studies defined in a part or assembly document. The selected Simulation studies are run automatically in a batch mode.

To open the Run Specified Studies dialog box:

  • Click Simulation > Run > Run Specified Studies, or
  • Click the down arrow on Run this study (Simulation CommandManager) and select Run Specified Studies .

Select the studies to run:

  Run Select the top check-box to run all listed studies or the individual check-boxes next to the studies to run.
  Study Name Shows the Simulation study name.
  Configuration Shows the Configuration name of the study on the same row.
  Mesh Status Shows the current status of the mesh data: OK or Out of Date.
  Results Status Shows the current status of the results data: OK, Failed, Running, or Out of Date.
If you select to run a study which is dependent on a parent study (such as a design, fatigue, sub-modeling, or pressure vessel study) the program will also run the parent study, if the mesh or the results of the parent study are out-of-date.
  Note Shows a message of the current status of each study and prompts an appropriate action.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Run Specified Studies
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.