Hide Table of Contents

When to Use Nonlinear Analysis

Linear analysis is based on the static and linearity assumptions and is, therefore, valid as long as these assumption are valid. When one (or more) of these assumptions fails, linear analysis will produce wrong predictions and nonlinear analysis must be used to model the nonlinearities.

The linearity assumption is true if:
  • All the materials in the model comply with Hooke's law, that is stress is directly proportional to strain. Some materials demonstrate such behavior only if the strains are small. As the strains increase, the stress-strain relationships become nonlinear. Other materials display nonlinear behavior even when the strains are small. A material model is a mathematical simulation of the behavior of a material. A material is said to be linear if its stress-strain relations are linear. Linear analysis can be used to analyze models with linear materials assuming that there are no other types of nonlinearities. Linear materials can be isotropic, orthotropic, or anisotropic. Whenever a material in the model demonstrates a nonlinear stress-strain behavior under the specified loading, nonlinear analysis must be used. Nonlinear analysis offers many types of material models.
  • The induced displacements are small enough so that you can ignore the change in the stiffness caused by loading. Nonlinear analysis offers a large deformation option when defining the material properties of a solid component or a shell. The stiffness matrix computations can be recomputed at every solution step. The frequency of recalculating the stiffness matrix is controlled by the user.
  • Boundary conditions do not vary during the application of loads. Loads must be constant in magnitude, direction, and distribution. They should not change while the model is deforming. For example, contact problems are naturally nonlinear because the boundary conditions change when loading contact occurs. However, linear analysis offers an approximate solution for contact problems where the large deformation effect is considered.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   When to Use Nonlinear Analysis
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.