Hide Table of Contents

Rotating a Model Using Animation Wizard

You can create a rotation without additional preparation.

To rotate a model:

  1. Click Animation Wizard Tool_Animation_Wizard.gif (MotionManager toolbar).
  2. In the Select an Animation Type dialog box:
    1. Select Rotate model.
    2. Select Delete all existing paths if you want to remove any existing animation sequences.
    3. Click Next.
  3. In the Select an Axis of Rotation dialog box:
    1. Select X-axis, Y-axis, or Z-axis for Select the axis of rotation.
    2. Type a value for the Number of rotations.
    3. Select Clockwise or Counterclockwise.
    4. Click Next.
  4. In the Animation Control Options dialog box:
    1. Type a value for the Duration (seconds) of the animation.
    2. Type a value for the Start Time (seconds) of the motion.
    3. Click Finish.
      Click Save Animation Tool_Save_Animation.gif (MotionManager toolbar) to save the animation.
The timeline is populated with changebars and key points, based on your selection for Duration and Start Time.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Rotating a Model Using Animation Wizard
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.