Hide Table of Contents

Reordering Bends

You can reorder the bends in a sheet metal part in which bends have been inserted.

To reorder bends in relation to each other:

  1. Right-click Flat-Pattern1 in the FeatureManager design tree, and select Reorder Bends.
    If you created the sheet metal part with the Insert Bends feature, right-click Process-Bends1, and select Reorder Bends.
  2. In the dialog box, click a bend name in the list, then click Move Up or Move Down to change the bend order.
  3. Repeat step 2 to move additional bends.
  4. Click OK.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Reordering Bends
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.