Hide Table of Contents

Configurable Items for Parts

You can vary the design of part configurations as follows:
  • Modify feature dimensions and tolerances.
  • Suppress features, equations, and end conditions.
  • Assign mass and center of mass.
  • Use different sketch planes, sketch relations, and external sketch relations.
  • Set individual face colors.
  • Control the configuration of a base part.
  • Control the configuration of a split part.
  • Control the driving state of sketch dimensions.
  • Create derived configurations.
  • Define configuration-specific properties.
  • Change the size of Hole Wizard holes.
  • Assign the material.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Configurable Items for Parts
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.