Hide Table of Contents

Adding to a Center Mark Set

In a center mark set, you can add additional center marks.

To create a center mark set in a drawing, you manually insert a linear or circular center mark. Then, in the Center Mark PropertyManager, and under Manual Insert Options, select Linear Center Mark or Circular Center Mark .

To add center marks to an existing center mark set:

  1. Right-click a center mark in the center mark set, and click Add to Center Mark Set.
  2. Select circular edges, slot edges, or arcs whose center marks you want to add to the center mark set.
  3. Click .
    If Connection lines is selected in the Center Mark PropertyManager, connection lines are automatically added where possible for the new center marks.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding to a Center Mark Set
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46