Hide Table of Contents

Revoking a Parallel Transition (For SOLIDWORKS PDM Professional only)

When you approve a parallel transition and then change your mind, you can revoke your approval.

A state change controlled by a parallel transition does not take place until the required number of users approves the transition. Until the state changes, any users who have run the transition can revoke their approval.

You can revoke a transition by using the Change State command or from the file's History dialog box.

To revoke a parallel transition by using Change State:

  1. Right-click the file for which you ran the transition and select Modify > Change State.
  2. From the submenu, select the transition you want to revoke.
    Transitions that can be revoked are shown as:

    Revoke_transition Revoke 'transition_name (n/n+)'

    where:

    • transition_name is the transition.
    • n is the number of users who have approved the transition.
    • n+ is the number of approvals needed to change the file's state.
  3. In the Revoke Transition dialog box, ensure that Revoke is enabled for the file.
  4. Click OK.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Revoking a Parallel Transition (For SOLIDWORKS PDM Professional only)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.61