Hide Table of Contents

Selecting and Building Brake Calipers

To select and build brake calipers:

  1. Click anywhere outside of the model to clear all selections.
  2. On the toolbar, click Selection Tool > Part to go to part mode.
    In the Palette, the thumbnails for hidden parts are grayed out.
  3. In the Palette:
    1. Ctrl + select each thumbnail to select the calipers and their logos.
    2. Under Vehicle Setup, click Create Calipers from Selected Parts.
    This builds the joints for the calipers.
  4. In the 3D Viewport, right-click and click Show All.
    The entire car is visible.
  5. Save the project.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Selecting and Building Brake Calipers
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Visualize and SOLIDWORKS Visualize Connected 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48