Hide Table of Contents

Components for User Defined Routes

Many common rectangular and circular section components, both parts and assemblies, are supplied in the Design Library. You can create your own custom components and libraries.

To create a ducting assembly, you must have the following components:
  • Duct end
  • Duct part
  • Duct elbows

The rectangular duct elbow fittings must have an alignment angle between 0, 90 and 270 angles.

You also need to add connection points to the fittings for a functional assembly. When the connection points are defined, you must also further define their alignment direction, for example, either vertical or horizontal.

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Components for User Defined Routes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46