Hide Table of Contents

Fixed Fastener Assembly with Float

To evaluate the worst case scenario considering fastener float:

In the PropertyManager, select Float fasteners and pins under Analysis Parameters.
The worst case minimum decreases to 47 while the worst case maximum increases to 53. The total range of 6mm is double the range of that without fastener float.

To achieve the worst case minimum result, TolAnalyst calculates the parts as described in the procedure where float is not considered. When the parts are assembled, the axle supports are pushed inward (as shown by the red arrows below) until the clearance holes make contact with the bolts, resulting in a minimum worst case of 47.





Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Fixed Fastener Assembly with Float
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21