Chamfers The sequence of diagnosis error messages for chamfers is as follows. Contents Chamfer - Width Ratio The chamfer face is too large relative to adjacent faces. Chamfer - Width The width of the chamfer is too large to recognize. Chamfer - Support Face Angle The angle between the support faces is too large. Chamfer - Edge Angle The angle of the chamfer face to adjacent faces is too large or too small. Chamfer - Cliff Chamfer Chamfer faces cannot eliminate adjacent faces. Chamfer - Multiple FeatureWorks does not recognize multiple chamfers at the same time. Chamfer - Vertex FeatureWorks does not recognize vertex chamfers. Chamfer - Invalid Selection The selection is not valid for chamfer recognition. Chamfer - General Failure The face does not represent a valid chamfer. Parent topicDiagnostic Error Messages Related concepts Boss and Cut Extrudes Fillets Holes Revolves General Errors