Low (faster) - High
(slower) and Deviation |
(For assemblies, available only if Apply to all referenced part documents (below) is
selected.) The slider controls the image quality resolution, and
Deviation is the maximum
chordal deviation in effect. Move the slider or enter a value in
Deviation. The slider
setting and deviation value are coupled and are inversely
proportional. |
Optimize edge length (higher quality, but slower) |
Increases image quality if, after you move the slider to the highest setting, you still want higher image quality.
This option causes slower system performance and increased file size.
|
Apply to all referenced part documents |
(assemblies only). Applies the settings to all of the part documents referenced by the active document.
|
Save tessellation with part document |
(parts only). Saves display information. When cleared, file size is reduced (often significantly), but the model is not displayed when the file is opened in view-only mode, the SOLIDWORKS Viewer, or eDrawings. The display data is regenerated when the file is opened again in SOLIDWORKS.
|