This setting applies to tolerance values for Arc Length, Chamfer,
Diameter, Hole Callout, Linear, Ordinate, Radius, as well as the display of tolerance values
that appear within other annotations such as notes and tables.
To
set trailing zeroes in tolerances:
-
Click .
-
In Zeroes, under Trailing zeroes
in Dimensions, select Show.
-
In Tolerances, select:
Show |
To display
trailing zeroes up to the number of decimal places applied
to each tolerance within the dimension (Bilateral, Limit,
and symmetric). |
Remove |
To remove
trailing zeroes from each tolerance (Bilateral, Limit, and
symmetric). |
Remove only on zero |
To remove
trailing zeroes from each tolerance when the displayed value
is zero. Also, when the value of the displayed tolerance is
not equal to zero, trailing zeroes are displayed up to the
number of decimal places that apply to each tolerance in the
dimension. |
-
Click
OK.