Hide Table of Contents

GetStateUndo

Returns the state for the Auto, Control, and Group options of the Undo command.

The variable stores the settings bit coded and returns the setting as a sum of the following:

Bit Codes

0 Undo is disabled
1 Undo is enabled and all operations can be undone
2 Only one step can be undone
4 Auto mode is turned on
8 A group is currently active
16 Zoom and Pan operations are grouped as a single operation

Properties

Type Integer (bit code)
Default 21
Status Read-Only
Saved Not saved

Related Commands

Undo



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   GetStateUndo
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46