General Techniques Contents Starting a New Motion Study You can create the first motion study for an assembly by clicking the Motion Study tab to the right of the Model tab toward the lower portion of the graphics area. Motion for Layout Sketches You can run Animation and Motion Analysis motion studies for layout sketch mechanisms you create from sketch blocks. Configuration-specific Motion Studies You can calculate motion study results for different model configurations. Creating Motor-based Motion Studies Motion studies motors simulate motion acting on a body as if it were applied by a motor. You can use motors in Motion Studies to move components in an assembly. Motion Study Properties PropertyManager Setting the Exact Time for Key Points and the Time Bar Edit Time Dialog Box You can specify the exact time for key points and the time bar in nanoseconds or other units. View Keys A View key is a view of the model at a particular point in time (camera view or model view). When to Use Interpolation You can use interpolation to simulate motion between key points in which there is a continuous value that changes at the end key point. You cannot use interpolation if you are simulating jumps in motion.