Hide Table of Contents

Constructing Arcs

You can construct arcs of any length or radius. You can also append Arcs to other Line, PolyLine, or Arc entities. All Arcs are drawn from the start point in the positive horizontal direction.

To construct Arcs from three points:

  1. Click Draw > Arc > 3 Points (or type Arc).
  2. In the graphics area, specify the start, through, and endpoints.

To construct Arcs from center points:

  1. Click Draw > Arc and specify a center-based option:
    • Start, Center, Angle: Lets you select the start and center point in the graphics area. Then you specify the value of the total angle from its chord.
    • Start, Center, End: Lets you select the start, center, and endpoint in the graphics area.
    • Start, Center, Length: Lets you select the start and center point in the graphics area. Then you enter the value of the arc chord length.
  2. Specify the required points in the graphics area or specify coordinate values.

To construct an Arc from start and endpoint options:

  1. Click Draw > Arc and specify a start and endpoint-based option:
    • Start, End, Angle to select the start point and endpoint in the graphics area, and specify the positive or negative value of the angle from the chord tangent to the start point.
    • Start, End, Direction to select the start point, endpoint, and tangent direction from the start point in the graphics area.
    • Start, End, Radius to select the start point and endpoint in the graphics area, and specify the value of the arc angle tangent from its chord.
  2. Specify the required points in the graphics area or specify coordinate values.

To append an Arc tangentially to a Line, PolyLine, or Arc:

  1. Click Draw > Arc (or type Arc).
  2. Specify the Append option.
  3. In the graphics area, select a Line, PolyLine, or Arc entity.

    - or -

    Press Enter if you want to append the Arc to the most recently drawn Line, PolyLine, or Arc.

  4. Specify the endpoint of the Arc.

To continue an Arc from the end of the most recently drawn Line, PolyLine, or Arc:

  1. Click Draw > Arc > Continue (or type Arc, then press Enter).
  2. In the graphics area, specify a through point (or select an option).
  3. Specify the endpoint of the Arc.

Access

Command: Arc

Menu: Draw > Arc



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Constructing Arcs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.