Hide Table of Contents

Cycling Through Entities During Selection

Selection cycling lets you selectively specify entities that are close to or on top of other entities.

You can preselect an entity with this method or use it when you are prompted to specify entities in the graphics area.

To cycle through entities during selection:

  1. Make sure pre-selection highlighting is selected (see Previewing and Highlighting Entity Selections).
  2. Hover the pointer over entities that are close to each other or overlap. All entities that pass through the selection box are selection candidates.
  3. Hold the Shift key and press the Spacebar repeatedly to highlight one entity after the other until the desired entity is highlighted.
  4. Release the Shift key and click the highlighted entity.
  5. Repeat steps 2 to 4 as needed to specify multiple entities that are close to each other or overlap.

Note: To set the Selection Box size, use the Options command (Click User Preferences > Drafting Options > Entity Selection > Selection Settings).



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Cycling Through Entities During Selection
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.