Hide Table of Contents

Creating a Spotlight

Use the Spotlight command to insert a spotlight into the drawing. A spotlight has a source position with light rays emanating in a specified direction, similar to a stage spotlight.

To create spotlights:

  1. Type Spotlight at the command prompt.
  2. Specify the source location.
  3. Specify the target location.
  4. Specify light source characteristics.

    See Creating a Light Source for light source characteristics.
  5. Specify the Exit option to create the light source.

    The light source displays in the graphics area.

  Executing the Light command using the Spot option does the same as the Spotlight command.


Command: Spotlight

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Creating a Spotlight
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: 2021 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.