List Thermal PropertyManager

To access this PropertyManager, after you run a Thermal study, right-click Results and select List Thermal.

Component

	Units	Select the units of the component.
	Component	Sets the thermal component to be searched for extreme values. The default is to list values within 5% tolerance of the Absolute Max value. TEMP Nodal temperature GRADX Temperature gradient in the X-direction of the selected reference geometry GRADY Temperature gradient in the Y-direction of the selected reference geometry GRADZ Temperature gradient in the Z-direction of the selected reference geometry GRADN Resultant temperature gradient HFLUXX Heat flux in the X-direction of the selected reference geometry HFLUXY Heat flux in the Y-direction of the selected reference geometry HFLUXZ Heat flux in the Z-direction of the selected reference geometry HFLUXN Resultant heat flux
	Time Step Number	Available for transient thermal analysis. Sets the time step at which results are to be listed. Default step is 1 for steady state thermal analysis.

Advanced Options

	Plane, Axis or Coordinate System	Select a reference plane, an axis, or a coordinate system to list stress. Used for directional components only.
	Extremes	Select this option to search for extreme values.
	Criterion	Sets the criterion for extreme values of results. Available list options are: Absolute Max Algebraic Max Algebraic Min
	Sort by value	Activates the sorting of the list.
	List all values within	Sets the range of values to be listed. The default is to list values within 5% tolerance of the extreme value.
	Range	Use this option to list values sequentially with node numbers. Enter the lowest and the highest node numbers.

List Set

Available only if Range is selected under Advanced Options.