|
End Condition |
Select an extrusion type.
|
|
Diameter |
Set a value for the hole diameter. Toggle
to change
the comparison symbols >, <, and =.
|
|
With Draft |
To select by draft angle, select With Draft and set a value for Angle. You can also select a draft
type: Only Inward, Only Outward, or Any. Toggle
to change
the comparison symbols, if necessary.
|
|
Reverse Offset |
Select Any, On, or Off. (For Offset From
Surface as End
Condition only.) |
|
Translate Surface |
Select Any, On, or Off. (For Offset From
Surface as End
Condition only.) |