Cyclic
reference |
The referenced file itself refers
back to the parent file and cannot be checked in. The detection of a cyclic reference always blocks check in.
|
File
name is not unique |
Another file of the same name
already exists in the vault. |
File
not found |
The referenced file is not
found. |
Local
file is modified |
A local copy of the referenced
file has been modified. |
Local
version has been overwritten |
A local version of the file has
been overwritten. |
Missing data necessary for BOM, needs resaving in
SOLIDWORKS |
The internal data required for
BOM is either missing or not updated leading to incorrect BOM
entries. To correct the BOM entries, resave the assembly file in
SOLIDWORKS. |
No
local copy |
The referenced file is present in
the vault but there is no copy in the local folder. |
Outside SOLIDWORKS PDM |
The referenced file is stored in a
location outside the file vault and will not be added as a reference
in SOLIDWORKS PDM for the parent
file (the actual reference is still stored in the physical parent
file.) |
SOLIDWORKS Drawing is saved in detailing
mode |
The drawing may be out of date
since it was saved without the resolved references. |
SOLIDWORKS Drawing is set to use Independent Revision
table |
The SOLIDWORKS drawing includes
an Independent type revision table. SOLIDWORKS PDM revision table integration supports use
of See Sheet 1 or Linked type revision tables. |
The
file is checked out by another user |
The referenced file is checked out
by another user. |
The
file is checked out in another folder |
The referenced file is checked out
in another folder. |
The
file is checked out on another computer |
The referenced file is checked
out on another computer. |
The
file is not rebuilt |
The file has been updated more
recently than a drawing or assembly that references it. Clicking
this warning will provide additional information regarding which
files need to be rebuilt. |
The
file is open in another application |
The user can close the file in
the other application and then check in the file. If the file is open in SOLIDWORKS
and the SOLIDWORKS PDM
add-in is installed, the user can check in from the add-in
without closing the file.
|
Toolbox file is located in a non-Toolbox
folder. |
The referenced Toolbox file is
outside the defined Toolbox root folder. |
Unknown file format |
The file format is not
recognized. |