| Name |
A unique value for each component.
The value in this field must match values in the From Part or To Part fields in the from-to list.
|
| SOLIDWORKS Document |
The name of the SOLIDWORKS part
for this component, such as db15e.sldprt or c:\myparts\plug.sldprt. This can be a relative
pathname (relative to the location of the component library
.xml file) or a full
pathname. |
| Configuration |
The configuration of the
SOLIDWORKS part to use for this component. |
| Description |
A text description of the
component. This field is for information only; the value is not used
by the software. |
| Pins
List |
A comma-delimited list of pin
names/numbers (for example, 1,2,3,4,5 or In, Out, Gnd). This field
is used only when you create a harness drawing. |
| Terminals
|
A comma-delimited list of terminal
part numbers that apply to the connector (for example,
3289435,34872634,485903). This field is used only when you create a
harness drawing. |
| Component
OuterDiameter |
A numeric value that specifies the outer diameter of
the component. |
| Size
(Gauge) |
A numeric value or dash-delimited
range of values representing the allowable sizes of terminals or
wires that can fit into the connector's pin cavities (for example,
2.5 or 2.5-4.0 for millimeters, or 20 or 20-24 for gauge). This
field is used only when you create a harness drawing. |
| Seal |
The part number of the sealing fitting used with
the component. |
| Plug
|
The part number of the plug used
with the component. |
| Miscellaneous |
The part number for any additional component used
with the base component. |