Change location
|
Contextual menu of a drawing: Change
location |
The Change location command
works across multiple drawings.
|
Drawing properties: Location |
Each drawing is associated with a location. This location is defined
when the drawing is created. By default, the location is the one associated
with the book.
When this command is selected, the location selection dialog box opens,
allowing you to select the desired location.
The components initially associated with the drawing's original location
can be associated with the new location. A dialog box opens allowing you
to select the desired options.
Change component location: Components
with the same location as the drawing are automatically associated with
the new location. If the component was drawn on several drawings, all
symbols representing the component are associated with the new location
(even if the drawings are not affected by the change of location). For
terminal strips, only the location of the terminals is changed. The terminal
strips are attached to remain in their initial location.
Change drawing location only:
The drawing itself is associated with the new location, and no changes
are made to the content of the drawing.
Cancel: Cancels the current
command. No changes are made to the drawing and its content.