Draw multiple wire
|
Menu: Schematic > Draw
multiple wire |
When you launch the command, the dockable panel updates to show the
selected wire parameters.
1. Click on
the graphical area where you want the wire to start.
2. Click the
second point to indicate where you want the wire to end.
The dockable panel displays the possible options.
|
Pins the command, ensuring that the command remains active
after it is first used. |
|
Stops the command after it is first used. |
|
Ends the command. |
|
Returns to the previous interface. |
|
Undoes the last action. |
Wire style selection
Name: You can change the wire
style by clicking on the [...]
button to the right of the wire name. This will open the Wire
style selector dialog box, letting you access the Wire
style management and select another wire name.
Space between lines: Modifies
the distance between the wires. The value is in either millimeters or
inches, depending on your electrical project settings (see unit
system in the electrical project configuration settings).
Available wires: Lists the type
of conductors that make up the currently selected wire style. Check the
conductor boxes you want to draw.
Options
Invert phase (Space): Press
the [Space] bar on the keyboard
to invert the conductors.
Draw bend (C key): Press the
[C] key on the keyboard to insert
bend.
Draw non ortho (F8): Press the
[F8] key on the keyboard to deactivate
the lock allowing you to insert the wires on an orthogonal axis.