Use the Toolbox - Surface Finish Symbol dialog box to configure the surface finish symbols you add to drawings.
To open the Toolbox - Surface Finish Symbols dialog box:
Do one of the following:
- Click Surface Finish Symbols
(Mechanical
Toolbox toolbar).
- Click .
Preview
As you configure the surface finish symbol, the preview changes to show how the symbol will appear in the drawing.
Properties: Non-JIS symbols
You can set the following properties for Basic, Machining Required, and Machining Prohibited surface finish symbols:
Local |
No all around designation is added to the surface finish symbol. 
|
All around
|
Adds an all around designation to the surface finish symbol. 
|
Lay
Direction
|
Indicates the primary direction of the surface pattern.
Select one of the following:
Parallel
|
Indicates that the surface pattern is parallel to the line that represents the surface to which the symbol is applied.
|
Perpendicular
|
Indicates that the surface pattern is perpendicular
to the line that represents the surface to which the symbol is applied.
|
Angular
|
Indicates that the surface pattern is angular in both directions to the line that represents the surface to which the symbol is applied.
|
Multidirectional
|
Multidirectional or random pattern.
|
Circular
|
Indicates that the surface pattern is approximately circular relative to the center of the surface to which the symbol is applied.
|
Radial
|
Approximately radial relative to the center of the surface to which the symbol is applied.
|
Protuberant
|
Indicates that the surface pattern is particulate, nondirectional, or protuberant.
|
No Lay Symbol
|
N/A
|
|
Material Removal Allowance
|
Sets the amount of material removed.
The value appears on the left side of the surface finish symbol.
|
Roughness Min
|
Sets the minimum degree of roughness.
Roughness is the average of values at random spots on the object surface.
These values appear on the upper middle side of the surface finish symbol.
|
Roughness Max |
Sets the maximum degree of roughness. |
Sampling Length & Other Roughness Values |
|
Roughness Spacing |
Sets roughness height and width.
These values appear on the right side of the surface finish symbol.
|
Production Method/Treatment |
|
Settings
Click Settings to open the Toolbox - Settings dialog box, where you can choose settings for leader display, text format, and layer preferences.
The dialog box opens to the Surface Finish Symbol screen of the Annotations category.
When you finish specifying settings, click OK to close the Toolbox - Settings dialog box and return to the Toolbox - Surface Finish Symbols dialog box.
Properties - JIS symbols
JIS Texture |
Indicates the amount of surface texture to be used with a JIS style, in conjunction with the Roughness Ra and Roughness Rz/Rmax values. To visually indicate a finer surface texture, attach more JIS texture symbols.
Not available for JIS Machining Prohibited.
|
Roughness Ra
|
Arithmetic average of
the absolute values of the vertical deviations of the roughness profile. |
Roughness Rz/Rmax
|
Based on the five highest peaks and lowest valleys over the entire sampling length.
|