Hide Table of Contents

Resetting the Scale Representations of Annotative Entities

Use the AnnReset command to reset all scale representations of specified annotative entities to their original position.

Alternate scale representations are the scales assigned to annotative entities. You can change the position of scale representions individually using EntityGrips.

To reset the scale representations of annotative entities:

  1. Click Modify > Annotation Scaling > Match Scale Positions (or type AnnReset).
  2. In the graphics area, specify annotative entities.
  3. Press Enter.

    The scale representations of the specified annotative entities are reset to the position of the current scale representation.

  Note: You can use the AnnReset command only on the Model tab or in the Model workspaces on layout Sheets.


Command: AnnReset

Menu: Modify > Annotation Scaling > Match Scale Positions

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Resetting the Scale Representations of Annotative Entities
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.