Adjusting Characteristic Locations

You can cut, copy, paste, move, and reorder characteristics on the drawing or in the Table Manager.

In a drawing, you use the Selection Tool to perform any of these functions. A blue rectangle in the drawing shows the selected item that you can cut, copy, paste, or move. A dotted blue rectangle around the characteristic or balloon indicates that you can move, cut, or copy the selected item.

Search 'Adjusting Characteristic Locations' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Adjusting Characteristic Locations
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

Just this topic
This topic and only immediate topics under it (up to 4 topics)

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS Inspection 2024 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.