Each drawing is associated with a location when the drawing is created.
By default, the location is associated with the book. You can change the location for
drawings.
-
Do one of the following:
- Right-click a drawing and click Change location.
- In Drawing
properties, click Location
- .
The location selection dialog box opens.
-
Select a new location.
The components initially associated with the drawing's
original location are associated with the new location.
-
In the dialog box, specify the following options:
| |
|
| Change
component location
|
Components with the same location as the
drawing are automatically associated with the new location.
If the component was drawn on several drawings, all symbols
representing the component are associated with the new
location (even if the drawings are not affected by the
change of location). For terminal strips,
only the location of the terminals is changed. The
terminal strips are attached to remain in their initial
location.
|
| Change drawing
location only |
The drawing itself is associated with the
new location, and no changes are made to the content of the
drawing. |
| Cancel |
Cancels the current command. No changes
are made to the drawing or its content. |