Hide Table of Contents

Finishing the Interlock Surface

Lofted Surface

Ruled Surface

Use Ruled Surface, rather than
Extend Surface to maintain the
correct taper.

Extend Surface

To facilitate Trim Surface.

Trim Surface , using Mutual
to remove material adjacent
to the horizontal ruled surface.

Knit Surface after trim.

Create a plane, parallel to Top
Plane.

Sketch rectangle to create a
planar surface.

Planar Surface

Trim Surface , using Standard
to trim below the planar surface.

After trim, the planar surface is ready
as the basis for tooling split operation.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Finishing the Interlock Surface
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26