Hide Table of Contents

Hole Callout Standards

All default standards for hole callouts (ANSI, ISO, Din, etc.) are defined in a text file under installation directory\solidworks\lang\<language>\calloutformat.txt.

If you require derived hole standards, you must define these in this file as well.

To define a derived hole callout standard:

  1. Locate and open calloutformat.txt.

  2. Copy and paste content describing the ANSI standard.

  3. Using only upper case letters, substitute the new derived standard name for ANSI in this copied section of text in the file.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Hole Callout Standards
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48