Smart Fasteners Hardware Stacks
Smart Fasteners does not automatically add nuts or washers to fasteners.
You add them in the Smart Fasteners
PropertyManager. Each Group of
fasteners has an associated Top Stack
(washers added under the head of the fastener) and Bottom
Stack (washers and nuts added to the end of the fastener).
|
See Toolbox
Help: Toolbox - Smart Fasteners to select or clear these options:
|
To add washers under a bolt head:
Right-click Smart
Fastener in the FeatureManager design tree and select Edit
Smart Fastener.
In the PropertyManager,
under Results, select the Group to which you want to add a washer.
Under Series
Components, select a washer in Add
to Top Stack.
The washer is added to Top
Stack .
If you want to add other sizes or types of washers
to Top Stack, select more components
from the list. If you add more than one type of washer, the first is next
to the bolted surface, and the subsequent washers are added toward the
bolt head.
In this example, the large washer was added
first, and then the smaller washer.
|
Top Stack |
To remove a component from
the stack, right-click it in Top Stack
and select Delete.
To add nuts and washers at the end of a bolt:
Under Series
Components, select a component in Add
to Bottom Stack.
The component is added to Bottom
Stack .
Select more components as needed. Add washers
first, and the nut last. The hardware appears in order from the bolted
surface toward the end of the bolt.
In this example, two small washers were added
first, and then the nut.
|
Bottom Stack |
Related Topics
Smart
Fasteners Overview
Editing
Smart Fasteners
Smart
Fasteners Nuts
Smart
Fasteners Washers