Hide Table of Contents

Importing Parts from a Folder

You can import all the SolidWorks parts from a specified folder into the Component Library.
  • Importing parts does not physically move parts on the disk. CircuitWorks just adds references to the library.
  • CircuitWorks adds the parts to the library using each component’s name on disk for both Component Name and Part Number fields.
  • If CircuitWorks is configured to match components in the library using name and height, then you must edit the component heights of the imported components to ensure CircuitWorks matches them rather than creating new models.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Importing Parts from a Folder
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26