Hide Table of Contents

Diagnostic Error Messages

During interactive recognition, if the software fails to recognize a feature, a detailed error message appears to explain the reason for the failure and to suggest possible solutions. The message also includes a link to a help topic.

The messages for each feature type follow a particular sequence. For example, suppose your model contains a cliff chamfer with a very large edge angle. FeatureWorks checks the edge angle first. If the chamfer fails the edge angle test, FeatureWorks does not proceed to the cliff chamfer test, so only a message about the edge angle problem appears.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Diagnostic Error Messages
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.