Hide Table of Contents

Using the Rollback Bar

To revert a part to an earlier state:

  1. Place the pointer over the rollback bar in the FeatureManager design tree.

    The pointer changes to .

  2. Drag the rollback bar up the FeatureManager design tree until it is above the features you want rolled back.

Rolling Back to Absorbed Features

To roll back to absorbed features:

  1. In the FeatureManager design tree, click the to expand the absorbed features within the parent feature.
  2. Right-click an absorbed feature, and select Rollback.

    A message appears that tells you the absorbed feature will be temporarily unabsorbed for editing purposes.

  3. Click OK.
  4. Drag the rollback bar below the feature you selected in step 2.

    The feature is unabsorbed and ready for editing.

You can also unabsorb some features by using Flat Tree Mode. Right-click the part in the FeatureManager design tree and click Tree Display > Show Flat Tree View.

Rolling a Model Forward

To roll a model forward:

  • Right-click a rolled back feature in the FeatureManager design tree, and select Roll Forward.

Rolling a Model to its Previous Rollback State

To roll a model to its previous rollback state:

  • Right-click in the FeatureManager design tree, and select Roll to Previous.

Rolling to the End of a Model

To roll to the end of a model:

  • Right-click in the FeatureManager design tree, and select Roll to End.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using the Rollback Bar
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26