Hide Table of Contents

Optimization Analysis (Available in SolidWorks Simulation)

Optimization analysis automates the search for the optimum design. SimulationXpress allows you to vary one design variable to find the optimal solution for one criterion. SolidWorks Simulation has additional optimization capabilities.

The Manual Process

In searching for the optimum design, you will need to manually try different geometry configurations, dimensions, materials, loads, and fixtures. Each time you make a change, you must rerun the analysis and examine the results.

The Automated Process

Optimization analysis automates the manual procedure for a particular configuration. Trends are detected quickly and the optimum solution is identified in the fewest number of test runs. Optimization analysis requires the following input:

Objective

States your objective, or goals. For example, you specify minimum material.

Design Variables or Geometry Constraints

Selects the dimensions, or variables, that can change and set their ranges. For example, you specify that the diameter of a hole can vary from 0.5" to 1.0" while the extrusion of a sketch can vary from 2.0" to 3.0".

Behavior Constraints

Sets the conditions, or constraints, that the optimum design must satisfy. For example, you specify that stresses, displacements, temperatures should not exceed certain values and the natural frequency should be in a specified range.

Output

SolidWorks Simulation attempts to find the optimum solution that satisfies geometry and behavior constraints.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Optimization Analysis (Available in SolidWorks Simulation)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.