Hide Table of Contents

Example: Using the SelectionManager

Example of how to use the SelectionManager:

  1. Open a part with a sketch. In this example, you create a loft from the sketch.
  2. Click Lofted Boss/Base (Features toolbar).
  3. Select the sketch line shown.



    The SelectionManager appears. The Select Group tool is active.

  4. In the SelectionManager, click the pushpin so the SelectionManager remains available.
  5. Select the three connecting sketch entities, then click .



    Closed Group<1> appears under Profiles .

  6. In the SelectionManager:
    1. Click Select Closed Loop .
    2. Select Auto-OK selections.
  7. Select the two loops one-by-one in approximately the same area to automatically add them to Profiles in the PropertyManager as Closed Loop<1> and <2>.

  8. Use Select Open Loop to select the four Guide Curves .
  9. Click .



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example: Using the SelectionManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26