Hide Table of Contents

Changing Envelopes into Regular Components

You can change envelope components into regular components.

To change an envelope into a regular component:

  1. Right-click an envelope in the graphics area or FeatureManager design tree and click Component Properties menu_Component_Properties.gif.
  2. In the lower right corner of the dialog box, clear Envelope.

    Exclude from bill of materials also becomes cleared.

  3. Click OK.

    The component is no longer an envelope. In the FeatureManager design tree, FM_envelope_part.png is replaced by FM_part.gif to indicate that the component is a regular component of the assembly. In the graphics area, the component is no longer transparent blue.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing Envelopes into Regular Components
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48