When SOLIDWORKS FloXpress completes the analysis, you can examine flow trajectories , which are the flow lines between the inlet and outlet openings. Trajectories are tangent to the flow velocity at every point.
To view results:
Set the PropertyManager options. When done, click to close FloXpress and save the results.
Animate
Starts the velocity plot animation. Select Pipes or Balls under Plot Settings.
Stop Animation
Stops the animation so you can change the Plot Settings to view a different animation.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2015 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.