Hide Table of Contents

Pad Filters

Use the Pad Filters panel to filter out pads by their type.

To open the Pad Filters panel:

Click the Tools tab, then click Pads in the Filter area of the Tools toolbar.

Pads are supported by IDF 4.0.
Bondwire Pads

Filter out bondwire pads.
Connector Pads

Filter out connector pads.
Pin Pads

Filter out pin pads.
Testpoint Pads

Filter out testpoint pads.
Via Pads

Filter out via pads.
Pads of no specified type

Filter out pads without a specified type.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Pad Filters
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48