Hide Table of Contents

Surface Bodies

Surface body is a general term that describes connected zero-thickness geometries such as single surfaces, knit surfaces, trimmed and filleted surfaces, and so on. You can have multiple surface bodies in a single part.

You can select a surface body from the graphics area using Filter Surface Bodies on the Selection Filter toolbar. You can select all types of surfaces with Filter Surface Bodies.

The pointer changes to when it is over a surface body. Surface bodies can include:
  • Single face surfaces
  • Multiple face surfaces
  • Knit surfaces
  • Filleted surfaces
  • Trimmed and extended surfaces
  • Imported surfaces
  • Planar surfaces and mid surfaces
  • Surfaces made by extrude, revolve, loft, sweep, offset, radiate, or fill
To select a single face in a complex surface body, use Filter Faces on the Selection Filter toolbar.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Surface Bodies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.