Default Options - Plot - Frequency/Buckling Study

Sets default result templates (folders and plots) for frequency or buckling studies. When you run a study that does not have any existing result plots, the software creates the folders and plots as specified in this page. If you run a study that has valid or invalid plots, the existing plots are updated regardless of the settings specified in this page.

To display the dialog box, click Simulation > Options. On the Default Options tab, expand Plot and click Frequency/Buckling Study Results.

Create plots for Specify the mode shapes to be plotted by default.

For All mode shapes

Create a plot for each extracted mode.

A defined number of mode shapes

Create plots for the specified number of modes. The actual number of created plots is the lowest of the number specified here and the number of actual modes extracted.

Results type Choose the type of plots to be created.

Amplitude

Plot an amplitude component.

Displacement plots

AMPX

X Amplitude

AMPY

Y Amplitude

AMPZ

Z Amplitude

AMPRES

Reusltant Amplitude