Hide Table of Contents

Working with Drawing Standards

Drawing standards let you check drawings against custom and corporate standards.

Drawing standards are saved in drawing standards files of type *.dws.

You can check the following standards settings in a drawing to achieve conformity:

  • Layers: Checks names, LineColor, LineStyle, and LineWeight properties. Layer display and locking settings (on/off, frozen/thawed, plotted/non-plotted, and locked/unlocked) are ignored.
  • LineStyles: Checks names, segment length, and spacing definitions.
  • DimensionStyles: Checks names and all Dimension variable settings. Dimension variable overrides are ignored.
  • TextStyles: Checks names and all attributes of the TextStyle definition, including font name, font format, text height, obliquing angle, spacing, and orientation settings (upside down, backwards, and vertical).

This section discusses:



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Working with Drawing Standards
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.