Hide Table of Contents

Auto Correct

Use Auto Correct All or Correct Selected to correct failed checks that support auto-correction.

To correct failed checks:

  1. With an open part, assembly, or drawing document, click Check Active Document (Design Checker flyout , Tools toolbar) or Tools, Design Checker, Check Active Document.

A Design Checker tab opens in the Task Pane.

  1. Select one or multiple drafting standards from the list of built-in standard files


Click Add Standards , browse for .swstd files, and select standard files to add.

  1. Click Check Document to check if the active document complies with the selected standard, and display the results.

 An alert appears if duplicate checks are found in multiple .swstd files. Design Checker uses the last occurrence of the check.

  1. Design Checker lists the failed checks in order of the criticality assigned to each check. Expand each individual entry to list the Parameter Name, Actual Value, and Preferred Value(s). For example:


Actual Value

Preferred Value(s)

Unit System



Dual Units




    1. Click Correct Selected to correct only the selected failed checks from the tree, or click Auto Correct All, to correct all failed checks for which Design Checker supports auto-correction.

 The failed checks are corrected with the values set in each of the Preferred auto correction values box.

Auto Correct All triggers revalidation of the active document. The Correct Selected tool does not trigger revalidation of the active document. You can click Recheck Document to revalidate the document.

    1. Click Close or Save Report to create a report.

To save a report:

  1. Click Save Report.

  2. In the dialog box, browse to a location and select:

  • Add report to Design Binder. Allows access to the report from the Design Binder in the FeatureManager design tree

  • View report on save. Displays the report after you click Save.

  1. Click Save.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Auto Correct
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.